MobileLock Remote Siren Strobe Combo
MobileLock Remote Siren Strobe Combo

MobileLock Remote Siren Strobe Combo

Your Price: $39.00
Part Number: DS509
Availability:
REMOTE SIREN/STROBE COMBO
Single tone piezo siren for indoor/outdoor use
6-14 VDC, 180 mA and 105 db at 12 VDC
Strobe flashes at same rate as siren sounding.
2.9" x 4.8" x 1.7"

Requires DS410 External Power Switch to be connected to DS600 Mobilelock



GENERAL SAFETY RULES
Warning: Read and understand all instructions and warnings before using this product.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR FAILURE
Do not use near water. Damage to the equipment may occur. Equipment should not be exposed to liquids or extreme humidity. Do not touch the electronic components inside the device.


Wiring Instructions
The following instructions are for wiring the DS406 siren to the DS410 Power Switch:
For a pulsed siren sound: Connect the siren's white wire into the “NO” port (Normally Open) on the DS410 using 16-18 gauge low voltage wire. Expose just enough of the bare wire before inserting and screw securely in place. Connect the siren's red wire to the + on the 12vdc adapter or + on the battery. Then connect the – on the 12vdc adapter or - on the battery to the “COM” port on the DS410. Tape off the siren's unused yellow wire. For a steady siren tone use
the yellow wire instead of the red wire and tape off the unused red wire. 
DS410 Instruction manual, REV 1, © 2019 MOBILELOCK LLC


Recently Viewed Items

TOP